Duct Heating Systems in Australia: 2026 Cost, Types & Buyer's Guide
A duct heating system is a whole-home heating solution that uses a central gas or electric reverse-cycle unit to warm air and push it through insulated ceiling or underfloor ducts to vents in every room. In Australia it remains the preferred whole-house heating choice for cold southern winters, delivering fast, even warmth from a single thermostat-controlled unit.

What Is a Duct Heating System?
A duct heating system (also called ducted heating) is made up of a heating unit, a return-air grille, a network of insulated flexible ducts, motorised zone dampers and supply vents. The unit draws cool air from inside the home, heats it using a gas burner or an electric heat pump, then forces the warmed air through the ducts and out into living spaces. Only the vents, return grille and controller are visible inside the home; the main unit sits outside, in the roof or under the floor. Modern systems support zoning so you heat only occupied rooms, which is the single biggest lever on running cost after the unit's star rating.
How Much Does a Duct Heating System Cost in Australia in 2026?
Indicative 2026 fully-installed pricing for a typical 3-bedroom Australian home: a gas ducted heater (4-5 star) costs $3,500-$7,500; a 6-star gas unit with zoning costs $5,500-$9,000; a reverse-cycle ducted system costs $5,000-$15,000; add-on refrigerated cooling using the same ducts adds $3,500-$7,000. Annual running cost for heating to 20C during occupied hours runs $900-$1,500 for gas ducted and $800-$1,600 for reverse-cycle ducted, depending on tariff, insulation and zoning behaviour. For a local quote on a ducted heating system tailored to your home, a licensed installer will perform a full heat-load calculation.
Which Is Better: Gas Ducted or Reverse-Cycle Duct Heating?
Gas ducted heating wins on raw cold-snap performance and lower upfront cost; reverse-cycle ducted heating wins on running cost, dual-purpose heating and cooling, and long-term regulatory risk. In 2026 reverse-cycle is generally cheaper to run in most Australian states because gas tariffs have risen and the electricity grid is increasingly renewable. Gas still edges ahead in deep cold climates where reticulated gas is cheap. Victoria's Gas Substitution Roadmap and the ACT's all-electric new-build rules mean gas heating carries higher future regulatory risk, while reverse-cycle aligns with Australia's electrification trajectory.
How Do You Choose the Right Duct Heating System?
Sizing is the most important decision. An undersized system runs constantly and never reaches setpoint; an oversized one short-cycles and wastes energy. A licensed installer performs a Manual J-style heat-load calculation using floor area, ceiling insulation, window glazing, orientation and climate zone. For gas ducted heating target a 4.5-6 star AGA gas energy rating; each extra star cuts gas consumption by roughly 10%. For reverse-cycle check the Zoned Energy Rating Label (ZERL) for your climate zone, targeting 5 stars or higher and a heat-pump COP above 4.0.
What Are the Installation Rules in Australia?
A duct heating system must be installed by licensed tradespeople in every state. Gas work requires a licensed gasfitter; electrical work requires a licensed electrician; any refrigerant-charged component (add-on cooling or reverse-cycle) requires an ARCtick-licensed technician under the Ozone Protection and Synthetic Greenhouse Gas Management Regulations 2004. New ductwork must meet National Construction Code (NCC) insulation requirements (typically R1.0-R1.5 for heating-only). In Victoria, high-efficiency upgrades may qualify for Victorian Energy Upgrades (VEU) discounts; nationally, reverse-cycle systems may attract Small-scale Technology Certificates (STCs).
How Long Does a Duct Heating System Last and How Is It Serviced?
A quality gas ducted heater lasts 15-20 years with annual servicing; a reverse-cycle ducted system lasts 12-15 years. The annual service includes cleaning the filter and heat exchanger, inspecting the burner and ignition, checking the fan and dampers, testing the thermostat, and for gas units a carbon monoxide (CO) leak test. Energy Safe Victoria recommends annual CO checks on all gas ducted heaters. Leaky ductwork can waste 20-30% of heated air, so ducts should be inspected every few years for tears, sagging and disconnected joints.
Frequently Asked Questions
Is a duct heating system gas or electric?
It can be either. Gas ducted heating uses a gas burner; reverse-cycle ducted heating uses an electric heat pump. Both deliver warm air through the same style of duct network.
How much does a duct heating system cost in Australia?
Expect $3,500-$7,500 for a gas ducted system and $5,000-$15,000 for reverse-cycle ducted, fully installed in a typical 3-bedroom home. Add-on cooling increases the price.
Which is cheaper to run, gas or reverse-cycle ducted heating?
In 2026 reverse-cycle is generally cheaper to run in most Australian states due to rising gas prices and the increasingly renewable electricity grid, though gas may still edge ahead in some cold-climate homes with cheap reticulated gas.
Can I install a duct heating system myself?
No. Gas fitting, electrical work and refrigerant handling are all licensed activities in Australia. A non-compliant install is illegal, voids warranty and may invalidate home insurance.
How long does a duct heating system last?
A well-maintained gas ducted heater lasts 15-20 years; a reverse-cycle ducted system typically lasts 12-15 years. Annual servicing extends lifespan and keeps the system safe.





Comments